Leprecon Watson Bedienungsanleitung

Power Management ProductsWatson Installation and User’s manual©Copyright Leprecon LLC. 2013All rights reservedPublication 21-1050 Rev CThis document i

10Delay MenuThe Non-Dim and Auto switch modes use a delay time to prevent immediate powerswitching. This can be useful in two situations:1) Momentary

11Software VersionFrom the main display, pressing the Menu key three times will display the currentsoftware version. In the example below, the softwar

126) Troubleshooting and ServiceService policyWatson is designed for a long, trouble free life. If you suspect that you have a problem,the first step

137) DMX 512 InformationThe following information is a summary of the USITT 1990 standard for dimmers andcontrollers. A complete copy may be obtained

2Table of ContentsFront panel Controls: Watson W1 ...31) Introduction ...

3Front panel Controls: Watson W1DMX outputIsolated DMX outputDMX Input

41) IntroductionWatson provides two important functions to support new technology (non-incandescent)lighting fixtures.1) Power Switching – using a se

5DMX Control inputAll Watson models accept DMX 512 1990 as specified by USITT. Reliable DMX systemsrequire cable rated for data communication at 250K

63) InstallationMountingEach Watson system ships with a simple metal bracket that will accept a standard Cclamp. The packaging for the bracket include

75) Front Panel ControlsWatson uses a 4 digit display and four entry switches to set operating modes, and showthe operating status. Address Menu:When

8After power on, the ULD-360 remains in the Address Menu . If no buttons are pressed,the display will blank after about 15 seconds.If Watson is in ‘Au

9Mode MenuThe Mode Menu sets the way Watson performs power switching.Press the Menu button once to enter set the operating mode:The display shows C1,